Skylink Charter

Swearingen SA227 Metro III

The airplane veered off the runway during a rejected takeoff, overran an airport sign, and impacted a hangar. The captain stated that during the after start checklist he moved the power levers to disengage the start locks on the propellers. Post accident examination found that the left propeller was still in the start lock position, while the right propeller was in the normal operating range. The captain was the pilot flying (PF) and the second-in-command (SIC) was the non flying pilot (NFP). After receiving their clearance, the PF taxied onto the runway and initiated the takeoff sequence. The SIC did not set and monitor the engine power during takeoff, as required by the company procedures. During the takeoff acceleration when the speed was between 40 and 60 knots, the captain released the nose gear steering control switch as the rudder became aerodynamically effective. When the switch was released, the airplane began immediately veering left due to the asymmetrical thrust between the left and right engine propellers. The PIC did not advise the SIC that he had lost directional control and was aborting the takeoff, as required by company procedures. The distance between where the PIC reported that he began the takeoff roll and where the first tire marks became apparent was about 630 feet, and the distance between where the marks first became apparent and where the airplane's left main landing gear tire marks exited the left side of the runway was about 220 feet. Thereafter, marks (depressions in the dirt) were noted for a 108-foot-long distance in the field located adjacent to the runway. Medium intensity tire tread marks were apparent on the parallel taxiway and the adjacent vehicle service road. These tread marks, over a 332-foot-long distance, led directly to progressively more pronounced marks and rubber transfer, and to the accident airplane's landing gear tires. Based on an examination of tire tracks and skid marks, the PIC did not reject the takeoff until the airplane approached the runway's edge, and was continuing its divergent track away from the runway's centerline. The airplane rolled on the runway through the dirt median and across a taxiway for 850 feet prior to the PIC applying moderate brakes, and evidence of heavier brake application was apparent only a few hundred feet from the impacted hangar. No evidence of preimpact mechanical failures or malfunctions was found with the propeller assemblies, nose wheel steering mechanism, or brakes.

Swearingen SA227 Metro III

After executing a missed approach at the Grand Canyon Airport, the pilots diverted to the Bullhead City Airport. The pilots reported that minimal icing conditions were encountered with about 1/8 inch of ice accumulating on the aircraft wings. The pilots stated they cycled the deice boots to shed ice. They did not observe ice on the propeller spinners, and they did not activate the engines' 'override' ignition systems, as required by the airplane's flight manual. Use of 'override' ignition was required for flight into visible moisture at or below +5 degrees Celsius (+41 degrees Fahrenheit) to prevent ice ingestion/flameouts. Subsequently, both engines flamed out as the airplane was on about a 3 mile final approach for landing with the landing gear and flaps extended. The aircraft was destroyed during an off-airport landing.