Exin

Antonov AN-26

On 25th August 2010 cargo aircraft An-26B, registration SP-FDP started from Tallinn-Lennart Meri-Ülemiste Airport to Helsinki. After uneventful flight preparations, the aircraft started its take-off roll on runway 08. Based on pilots statements and FDR/CVR recordings the aircraft entered runway 08 from taxiway B on the West end of the runway and lined up for takeoff. On 16:47:22 the aircraft started its takeoff roll. The calculated V1 was 182 and Vr was 201 km/h. 10 seconds later PF started rotation without Vr callout at 123 km/h. The aircraft pitch angle increased to 4.6° 2 seconds later. At 16:47:38 the navigator made V1 call-out at 160.5 km/h. 1 second later flight engineer called “Retracting” in Polish. The aircraft started to pitch down and 3 seconds later it contacted the runway and continued on its belly for 1,228 m before coming to its rest position 3 m right from the runway centerline. No persons were injured and no fire broke up. The occurrence was classified as an accident due to the substantial damage to the aircraft structures.

Antonov AN-26

Exin Co was operating An-26B for regular cargo flight between Tallinn and Helsinki. The crew performed last maintenance check in Tallinn on previous day and made uneventful flight to Helsinki on 17th March afternoon. Next morning the aircraft took off from Helsinki for regular flight EXN3589 to Tallinn at 09:46 local time. The takeoff weight was 23,954 kg, 46 kg below the MTOW. Four crewmembers, company mechanic and one cargo attendant were on board. During takeoff crew used RU 19-300 APU for additional thrust as prescribed in AFM. The RU 19-300 was shot down after takeoff. The flight was uneventful until 08:14:50, 9.5 nm from the runway 26. When power levers were retarded to flight idle crew noticed engine vibration and smelled a smoke in the cockpit. The engine chip detector indicator in the cockpit was lit. After short discussion about which engine should be shot down the flight engineer shot down the left engine and the captain tried to start the RU19A-300 (APU) to gain more thrust. During the approach the air traffic controller noticed the aircraft deviation from the approach path to the left and notified the crew. According to the FDR and CVR data the crew was unable to maintain a proper approach path both in lateral and vertical dimensions. The attempts to start RU19A-300 engine failed. Visual contact with the RWY was established 0.5 nm from the threshold. The aircraft crossed the airport boundary being not configured for landing and with IAS 295-300 km/h. The flaps were extended for 10° over the threshold; the landing gear was lowered after passing the RWY threshold and retracted again. The aircraft made a high speed low path over the runway on ca 10-15 feet altitude with the landing gear traveling down and up again. Flaps were extended over runway, and then retracted again seconds before impact. At the end of the RWY the full power on right engine was selected, aircraft climbed 15-20 feet and started turning left. Crew started retracting flaps and lowered landing gear. Aircraft crossed the highway at the end of the RWY on altitude ca 30 feet, then descended again, collided with the treetops at the lake shore and made crash-landing on the snow and ice-covered lake waterline. Due to the thick ice the aircraft remained on the ice and glided 151 m on the ice with heading 238° before coming to full stop. After the impact the flight engineer shoot down the RH engine and power and released all engine fire extinguishers. All persons onboard escaped immediately through the main door. No emergency was declares and despite suggestions from FO go-around was not commanded.